*This Training is designed for SPPID Power User.
1) Line selection: how to decide draw a primary line or a secondary line?
1) Line selection: how to decide draw a primary line or a secondary line?
Primary Flow will use Primary line, others use secondary line.
2) Direction: draw starting from left to right, or from right to left?
Always draw flow the OPC (off page connector) 's direction, then put the flow direction arrow on.
3) How to label flow arrow?
Just directly put the arrow on the line. do not waiting the "...." appear, then click 1,2.. change the direction. Do not do that. cos. it will affect LDT from and to automatic runing.
4) Label line number
Find the right label, then put it on the top of the line, fill the all the information.
5) How to join two run which carried different information?
a.click the inconsistency, see what is the difference and deceide which side information is going to keep.
b.click copey one to another one. (highlight part shall be recovered.)
6) How to put segment break? (basic job)
a. move flanges, keep the connected point at grid.
b. click one line, then break in the middle of the flange.
Then, put the segment break label on the break point.
a. move flanges, keep the connected point at grid.
b. click one line, then break in the middle of the flange.
Then, put the segment break label on the break point.
7) Insulation label (include PP, E, HC)
Keypoint, put the insulation segment break first, then put insulation on the line.except all the line are same insulation.
Keypoint, put the insulation segment break first, then put insulation on the line.except all the line are same insulation.
